kukko 482-1 handy 2-arm puller 60 x 40 mm with autogrip for removing bearings, gears, and discs in tight and hard-to-reach spaces Ball Insert Bearing Rounded sides of pipeliner files

Rounded sides of pipeliner files are single-cut

The Whittet-Higgins SC-09A is a two-piece (split) shaft collar machined to inch dimensions

and portable drilling jobs

1 minutes Modes Thermometer mode Yes Bearing temperature mode Yes Power Management Power level 8 levels: 10-20-30-40-50-60-80-100% Magnetization Automatic demagnetization / residual magnetism Yes / < 2 A/cm Suitability Suitable for heating sealed bearings Yes Suitable for heating pre-greased bearings Yes Suitability for precision bearings Yes Safety Thermal overload protection Yes Error guide codes Yes

8°F) Measurement & Analysis AVG Last 20 readings Differential (MAX/MIN) Yes Max/Min Min/Max/Avg/Dif Measurement Resolution 0

kukko 482-1 handy 2-arm puller 60 x 40 mm with autogrip for removing bearings, gears, and discs in tight and hard-to-reach spaces Ball Insert Bearing Rounded sides of pipeliner filesThe handy 2 jaw puller with force amplifying, self centering, and gripping jaws is used for removing bearings, gears, and discs in tight and hard to reach spaces. It allows for the removal of any component that sits on a shaft and is freely accessible from the outside. The built in force amplification with spring mechanism increases the clamping force proportionally to the pulling force. By tightening the spindle, the jaws are automatically centered.