Parker Vacumatic Tap Tool to Straighten Bushing Threads Size of Thread:Small 0.093 inch Outer Diameter I say almost

I say almost

This is a Laureat I body with modified Lauriat II front end

They CAN be put in a Dremel or flex shaft drill

use the round cross section pick

These three Saffords were found in a shoe box full of pens found in the closet of the home of a former Parker employee by his daughter

Parker Vacumatic Tap Tool to Straighten Bushing Threads Size of Thread:Small 0.093 inch Outer Diameter I say almostA TAP FOR STRAIGHTENING OUT THE THREADS IN THE CLIP BUSHING IN THE CAP OF A PARKER VACUMATIC 51 AFTER YOU'VE REMOVED THE BROKEN OFF PLASTIC CLIP SCREW ("JEWEL") FROM THE BUSHING. Clip screws sometimes shear off when you're trying to remove them when you need to get at the clip bushing slot to remove the clip. You then have to use a bud burr and or a pick to break up the threaded part of the clip screw ("Jewel") that remains stuck in the clip bushing